Industrial Paints, Specialty Coatings & Anti-Rust Solutions

IMPREUS Nano Coat

A water-based nanotechnology chemical that stops rust formation on mild steel.

IMPREUS Nano Coat
Anti-Rust Chemicals
Nano-technology rust-prevention chemical

In plain words: A water-based liquid you put on steel before painting to stop rust from forming. It can also treat light rust that is already there.

IMPREUS Nano Coat is a water-based liquid that stops rust from forming on mild steel. It also turns light rust that is already on the surface into a nano coat. Use it on mild steel and reinforcement steel before painting, powder coating or electroplating.

At a glance
Product typeNanotechnology rust-prevention chemical
Suitable substrateMild steel, reinforcement steel
Intended useBefore painting, powder coating or electroplating

Key features

  • Stops rust from forming on mild steel
  • Turns light existing rust into a nano coat
  • Inorganic, water-based formula

Where it is used

  • Mild steel
  • Reinforcement steel
  • Treatment before painting, powder coating or electroplating

See how IMPREUS Nano Coat works

LIGHT RUST ON MILD STEELCLEAN OFF DIRT AND LOOSE RUSTNANO COAT: WATER-BASED LIQUIDREADY FOR PAINTING

Directions for use

  1. Surface preparationMake sure the surface is clean, dry and free from rust, oil, grease, dust and loose particles. Remove rust and scale by wire brushing, grinding or sand blasting wherever possible.
  2. MixingStir the contents thoroughly before use. For two-component systems, mix the base and hardener in the recommended ratio and use within the specified pot life.
  3. ApplicationApply by brush, roller or spray, depending on site conditions. Apply one or two coats as recommended to get uniform coverage.
  4. ThinningIf required, dilute with a suitable thinner or water in a small quantity, as recommended for proper application.
  5. RecoatAllow adequate drying time between coats.
  6. PrecautionApply only on clean and dry surfaces. Avoid application during rain, high humidity or on wet surfaces.

How to apply

Surface preparation: Remove dirt, oil, grease and loose rust. On hot-rolled steel, also remove loose mill scale (the flaky outer layer). Apply on a dry, dust-free surface.

Application method and conditions follow the approved technical data sheet.

Technical data & downloads

Coverage, drying time, DFT, pack sizes and finish are provided in the approved TDS / SDS, with revision date.

Request TDS / SDS

FAQs

What surface preparation is required?

Remove dirt, oil, grease and loose rust. On hot-rolled steel, also remove loose mill scale (the flaky outer layer). Apply on a dry, dust-free surface.

Can I get the TDS and SDS?

Yes. Request the technical data sheet and safety data sheet and our team will share the current revision.

How do I know if this suits my asset?

Suitability depends on the substrate, surface condition and operating environment. Share these details with our team and we will advise.

More in Anti-Rust Chemicals

Related products

Anti-Rust Chemicals

Escale Remover

A 100% organic cleaning liquid for non-ferrous metals: scale removal, sanitising and water marks removal.

100% organicNon-ferrous metals100 ml spray
Technical consultation

Not sure which coating is right?

Tell us about your asset, surface condition and operating environment. Our technical team will help you identify a suitable solution.

Chat on WhatsApp