Industrial Paints, Specialty Coatings & Anti-Rust Solutions

Tools

Quick calculators for coverage, mixing, weather and units. Estimates only: always follow the product data sheet.

Coverage and wet film

–Wet film, µm
–Theoretical, m²/L
–Practical, m²/L
–Paint needed, litres

Use the volume solids and DFT from the product data sheet. Loss depends on the method and surface (spray, rough steel and wind increase it).

Mixing ratio (two-pack)

–Base
–Hardener

The product data sheet says whether the ratio is by volume or by weight. Mix only what you can use within the pot life.

Dew point check

–Dew point, °C
–Steel above dew point, °C

Estimate using the Magnus formula. Measure the steel temperature with a surface thermometer. Always follow the limits on the product data sheet.

Microns to mils

1 mil = 25.4 microns. Data sheets use either unit.

These tools give estimates from the numbers you enter. They do not replace the approved technical data sheet or an inspector's measurements.

Technical consultation

Want a second opinion?

Send us your numbers and our team will check them with you.

Chat on WhatsApp