Industrial Paints, Specialty Coatings & Anti-Rust Solutions

Common Mistakes During Industrial Painting

Most paint problems come from a few mistakes that are easy to avoid: poor preparation, wrong mixing and wrong conditions.

Application · 2 min read

Key points

  • Poor surface preparation is the biggest cause of failure
  • Two-part paints must be mixed in the right ratio
  • Weather and surface conditions matter
  • Watch the thickness, working time and waiting time between coats

1. Skipping or rushing preparation

Painting over oil, dust, salt, loose rust or mill scale. See "Why Surface Preparation Matters Before Painting".

2. Wrong mixing ratio or poor mixing

Two-part paints harden by a chemical reaction, so the base and hardener must be mixed in the stated ratio (for example 4 to 1, 2 to 1 or 1 to 1) and mixed well. Guessing the amounts can leave the paint soft, sticky or brittle.

3. Ignoring pot life

Once mixed, a two-part paint can only be used for a limited time. This is its pot life. Applying it later gives poor results. Mix only what you can use in that time.

4. Painting in the wrong conditions

  • The surface should be clean and dry
  • A common rule is to keep the steel at least 3 °C warmer than the dew point
  • Avoid painting in rain, fog or very damp air unless the product allows it
  • Check the lowest and highest temperatures on the data sheet

5. Wrong thickness

Applying the coat too thin or too thick. Check the wet film while painting and the dry film afterwards.

6. Missing the recoat window

Each system gives a minimum and maximum time between coats. Too soon can trap solvent. Too late may need light sanding so the next coat sticks.

7. Wrong thinner or mixing different systems

Use only the thinner the product recommends. For example, IMPREUS PU Thinner is for thinning PU systems as directed on the data sheet. Mixing paints from different families can make them lift or wrinkle.

8. Forgetting edges, welds and bolts

These spots often get too little paint and fail first. An extra coat by brush on them helps.

Ask a question about this topic

Not sure how this applies to your asset? Send a short question and our technical team will reply by email.

This article is general guidance. Always follow the surface preparation, mixing, application and safety information on the product's approved technical data sheet. Standards are listed for reference.

References

  • ISO 12944-7: Execution and supervision of paint work
Technical consultation

Not sure which coating is right?

Tell us about your asset, surface condition and operating environment. Our technical team will help you identify a suitable solution.

Chat on WhatsApp