Industrial Paints, Specialty Coatings & Anti-Rust Solutions
Home/Knowledge Centre/Industry knowledge

Corrosion Challenges in Coastal Environments

Salt, damp air and constant wetting make the coast one of the hardest places for steel.

Industry knowledge · 2 min read

Key points

  • Salt in the air and on surfaces makes rust faster
  • Damp air and repeated wet and dry cycles keep steel wet
  • Marine structures have three zones: air, splash and underwater
  • The coating must suit the zone and the maintenance plan

Why the coast is hard on steel

Sea air carries salt. The salt lands on steel and soaks up moisture, so the surface stays damp even without rain. Salt also breaks down the thin natural film on steel. Wind, spray and temperature changes add to the effect.

Corrosivity categories

The standard ISO 12944-2 sorts environments from C1 (very low corrosion) to C5 (very high), plus CX for extreme offshore. Salty coastal and marine areas fall in the highest categories. The category helps decide how tough the coating system needs to be.

The zones of a marine structure

  • Air zone (atmospheric): above the splash, exposed to salty air
  • Splash zone: wetted and dried again and again. Usually the hardest zone.
  • Underwater zone (immersed): always under water. It needs a system chosen for that.

Preparation matters even more

Salt left on blasted steel can cause blisters under the paint. Near the coast, check for salt and wash it off before coating. Coat soon after preparing, because steel can start to rust again within hours in damp air.

Product note

IMPREUS Corrosion Barrier Coat is a thick middle coat for iron and steel, highly recommended for areas near the sea. Tell our team your exposure zone and the condition of any existing coating to discuss a suitable system.

Ask a question about this topic

Not sure how this applies to your asset? Send a short question and our technical team will reply by email.

This article is general guidance. Always follow the surface preparation, mixing, application and safety information on the product's approved technical data sheet. Standards are listed for reference.

References

  • ISO 12944-2: Classification of environments
  • ISO 9223: Corrosivity of atmospheres
Technical consultation

Not sure which coating is right?

Tell us about your asset, surface condition and operating environment. Our technical team will help you identify a suitable solution.

Chat on WhatsApp