Industrial Paints, Specialty Coatings & Anti-Rust Solutions
Home/Knowledge Centre/Industry knowledge

Corrosion Considerations in Salt and Sugar Plants

Damp air, process residues and plant conditions can all cause corrosion in salt and sugar plants. Start by understanding the assets and the conditions.

Industry knowledge · 2 min read

Key points

  • Damp, humid conditions are common
  • Salt and process residues can stay on surfaces
  • Cleaning and washing routines affect coatings
  • Conditions differ between plants and areas, so check before choosing

Why these plants are hard on steel

Salt works and sugar mills have damp air, steam, washing and process residues. Salt crystals soak up moisture from the air and keep salt against the steel. In sugar plants, process liquids and condensation can wet the structures, and conditions change from area to area.

Assets to look at

  • Plant steel structures and supports
  • Process equipment and vessels
  • Storage and handling assets
  • Pipes and ducts, including places where water condenses

What to check before choosing a coating

  • Which assets are affected and how long they have been in use
  • Moisture, residues and temperature in each area
  • Whether the surface is bare steel or already coated
  • How the plant is cleaned and washed
  • Any food-contact or hygiene rules that apply

Preparation and residues

Residues left on surfaces can affect how well a coating works. Thorough cleaning, including removing salts and other contaminants, is part of preparation. Follow the preparation on the product data sheet.

Food-contact areas

If a lining touches food or drinking-quality products, check which approvals and documents are needed for that use before choosing a product. Our team can discuss your requirement. IMPREUS Solvent Free Epoxy Food Grade Coating is a solvent-free epoxy lining for storage tanks and equipment.

Ask a question about this topic

Not sure how this applies to your asset? Send a short question and our technical team will reply by email.

This article is general guidance. Always follow the surface preparation, mixing, application and safety information on the product's approved technical data sheet. Standards are listed for reference.

References

  • ISO 12944-2: Classification of environments
Technical consultation

Not sure which coating is right?

Tell us about your asset, surface condition and operating environment. Our technical team will help you identify a suitable solution.

Chat on WhatsApp