Industrial Paints, Specialty Coatings & Anti-Rust Solutions
Home/Knowledge Centre/Coating selection

How to Choose an Anti-Rust Primer

There is no single best primer. The right one depends on the metal, how well you can prepare it, where it is used and what goes on top.

Coating selection · 2 min read

Key points

  • Start with the metal: steel, galvanized steel or aluminium
  • Pick a primer that suits the preparation you can really do
  • Check that it works with the paint that goes on top
  • Think about workshop or site, welding and one can or two

Questions to answer first

  • What is the metal: steel, galvanized steel, aluminium or reinforcement steel?
  • How will you prepare it: by hand tools or by blasting?
  • Where will it be used: indoors, outdoors, near the sea, around chemicals?
  • Will it be painted in a workshop or on site?
  • What paint will go on top, and does it work with this primer?
  • Will there be welding or cutting after priming?
  • One can or two? Can your team mix and use a two-part product in time?

How the IMPREUS primers differ

The table below sums up what each product page says. It is a guide to the range, not advice for a specific asset.

PrimerPackWhat the data says
Low VOC Metal PrimerSingle can, water-basedApplied in a workshop on steel, galvanized steel and aluminium; light to moderate industrial conditions
Chlorinated Rubber Based PrimerSingle can, dries in airStructural steel outdoors and in mildly corrosive conditions
High Build Grafted Co-Polymer PrimerZinc-richBare steel; does not affect welding or cutting; applied before fabrication
Corrosion Barrier CoatMiddle coatRust-preventing middle coat for iron and steel; recommended near the sea
Epoxy Primer (4:1)Two partsTwo-part epoxy primer, mixed 4 parts base to 1 part hardener
Red Oxide PrimerSingle canRed oxide primer in the IMPREUS primer range

Do not choose on its own

A primer is one layer of a system. Make sure it works with any middle coat and the final paint, and plan the waiting time and thickness for each coat. Tell our team about the asset, surface and surroundings and we will help you shortlist.

Ask a question about this topic

Not sure how this applies to your asset? Send a short question and our technical team will reply by email.

This article is general guidance. Always follow the surface preparation, mixing, application and safety information on the product's approved technical data sheet. Standards are listed for reference.

References

  • Product information: IMPREUS product pages and technical data sheets
Technical consultation

Not sure which coating is right?

Tell us about your asset, surface condition and operating environment. Our technical team will help you identify a suitable solution.

Chat on WhatsApp