Industrial Paints, Specialty Coatings & Anti-Rust Solutions
Home/Knowledge Centre/Surface preparation

Rust Removal: What to Check

Before you remove rust, look at what kind it is, how deep it goes and what else is on the surface. A short check saves a lot of rework.

Surface preparation · 2 min read

Key points

  • Tell loose rust and flakes from firmly stuck rust
  • Look for pits, because they hold rust and salt
  • Check for oil, grease, water and salt
  • Choose cleaning by tools or a chemical treatment to suit the surface and the next coat

1. How bad is the rust?

The standard ISO 8501-1 describes four starting conditions of steel. A: mostly covered in mill scale, little rust. B: some rust, some scale flaking off. C: scale has rusted away or can be scraped off, with a little pitting. D: scale rusted away, with pitting everywhere. The worse the grade, the more preparation work is needed.

2. Is the rust loose or stuck?

Loose rust, flaking scale and peeling old paint must come off. Firmly stuck rust must either be removed or treated, depending on the coating system you plan to use. The data sheet will tell you.

3. Look for pits and gaps

Pits and gaps keep rust, water and salt even after cleaning. They need extra attention. Check them in good light.

4. Check for contamination

  • Oil and grease: remove with solvent or detergent before any grinding or blasting
  • Salt: especially near the coast
  • Dust: remove it after blasting or grinding
  • Water: the surface must be dry, and steel should be warmer than the dew point

5. Choose the method

Cleaning by tools (wire brush, power tools, blasting) removes rust physically. A chemical treatment is another option on suitable surfaces. For example, IMPREUS Nano Coat is a water-based liquid for mild steel and reinforcement steel. It is used before painting, powder coating or electroplating, and it turns light rust already on the surface into a nano coat.

Follow its preparation steps: remove dirt, oil, grease and loose rust, and apply on a dry, dust-free surface.

6. Coat quickly

Clean steel can start to rust again fast, especially in damp or coastal air. Plan to coat it within the time given on the data sheet.

Ask a question about this topic

Not sure how this applies to your asset? Send a short question and our technical team will reply by email.

This article is general guidance. Always follow the surface preparation, mixing, application and safety information on the product's approved technical data sheet. Standards are listed for reference.

References

  • ISO 8501-1: Rust grades A, B, C and D
Technical consultation

Not sure which coating is right?

Tell us about your asset, surface condition and operating environment. Our technical team will help you identify a suitable solution.

Chat on WhatsApp