Industrial Paints, Specialty Coatings & Anti-Rust Solutions
Home/Knowledge Centre/Corrosion basics

Common Types of Industrial Corrosion

Rust does not always look like an even orange layer. Knowing which type you have helps you check and protect the asset properly.

Corrosion basics · 2 min read

Key points

  • General corrosion is even and easy to spot
  • Pitting and crevice corrosion hide in small spots and gaps
  • Two different metals touching can cause corrosion
  • Corrosion under insulation is often found late

General corrosion

The whole surface rusts more or less evenly. It is the easiest type to see and to plan for. You often find it on outdoor steel whose paint has worn off over a large area.

Pitting

Small spots rust deeply, like tiny holes, while the rest of the surface looks fine. A pit can eat through the steel in one place. Rust and dirt inside pits are hard to clean out before repainting.

Crevice corrosion

This happens in tight gaps, for example under bolt heads or where two plates overlap. Water gets trapped and cannot dry. Good design and sealing help here as much as coatings do.

Corrosion between different metals

When two different metals touch and water is present, one of them corrodes faster. Examples are steel bolts on aluminium, or copper pipe touching steel.

Corrosion under insulation

Water can creep into insulation and sit against a pipe or vessel for months. The steel stays wet and the damage is hidden. It is often only found when the insulation is taken off.

Wear and flow damage

Liquids carrying solid particles, or constant rubbing, can scrape off the coating. Corrosion then follows. Tough, wear-resistant coatings are used for these places.

Why it matters

The type of corrosion tells you what to inspect, clean and protect. A tank inside, a seaside jetty and a hot pipe each need a different conversation before choosing a product.

Ask a question about this topic

Not sure how this applies to your asset? Send a short question and our technical team will reply by email.

This article is general guidance. Always follow the surface preparation, mixing, application and safety information on the product's approved technical data sheet. Standards are listed for reference.

References

  • ISO 8044: Corrosion of metals and alloys, basic terms and definitions
Technical consultation

Not sure which coating is right?

Tell us about your asset, surface condition and operating environment. Our technical team will help you identify a suitable solution.

Chat on WhatsApp