Industrial Paints, Specialty Coatings & Anti-Rust Solutions
Home/Knowledge Centre/Surface preparation

Why Surface Preparation Matters Before Painting

Most paint failures start at the surface, not in the can. Good paint on a dirty surface will not last.

Surface preparation · 2 min read

Key points

  • Paint is only as strong as its grip on the surface
  • Oil, dust, salt, loose rust and mill scale must be removed first
  • Blasting cleans well and leaves a rough surface the paint can grip
  • Always follow the preparation on the product data sheet

Grip decides how long paint lasts

A coating protects only while it stays stuck to the surface. If there is dirt between the paint and the steel, the paint sticks to the dirt, not to the steel. Later it blisters, peels or rusts through.

Surface preparation removes what should not be there and gets the surface ready for the paint to grip.

DIRTY SURFACECLEAN SURFACE DAY 1: BOTH LOOK THE SAME6 MONTHS LATERPAINT PEELSPAINT LASTS

What needs to be removed

  • Oil, grease and dirt
  • Loose rust and loose mill scale (the flaky outer layer on new steel)
  • Old paint that is peeling or does not suit the new paint
  • Salts, especially from sea air. They can cause blisters under the paint.
  • Dust left after blasting or grinding
  • Any water on the surface

How surfaces are prepared

Methods range from cleaning with solvent or by hand, to power tools, to abrasive blasting (shooting fine grit at the surface). For harsh conditions, blasting is usually preferred. It removes rust and scale thoroughly and leaves a slightly rough surface.

Cleanliness grades

A standard called ISO 8501-1 gives names to how clean blasted steel is: Sa 1, Sa 2, Sa 2½ and Sa 3. Sa 2½ means very thorough cleaning: no visible oil, dirt, mill scale, rust or old paint, apart from slight staining. Many industrial data sheets ask for Sa 2½.

Surface roughness

Blasting leaves tiny peaks and valleys. This roughness is measured in microns (thousandths of a millimetre) and helps the paint grip. Some IMPREUS data sheets give a range, for example 50 to 100 microns for glass flake epoxy and 50 to 75 microns for the solvent-free tank lining.

Follow the data sheet

Different products need different preparation. A water-based workshop primer, an aluminium epoxy that works with basic preparation, and a tank lining each have their own rules. Always follow the preparation on the product page and its technical data sheet.

Ask a question about this topic

Not sure how this applies to your asset? Send a short question and our technical team will reply by email.

This article is general guidance. Always follow the surface preparation, mixing, application and safety information on the product's approved technical data sheet. Standards are listed for reference.

References

  • ISO 8501-1: Preparation of steel substrates before application of paints, visual assessment of surface cleanliness
  • ISO 8503: Surface roughness characteristics of blast-cleaned steel
Technical consultation

Not sure which coating is right?

Tell us about your asset, surface condition and operating environment. Our technical team will help you identify a suitable solution.

Chat on WhatsApp