Industrial Paints, Specialty Coatings & Anti-Rust Solutions
Home/Reference/Articles/Coating types

Epoxy, Polyurethane and Acrylic Coatings Compared

These three families cover much of industrial painting. Each has strengths, and they are often used together in one system.

Coating types · 2 min read · Updated 18 Nov 2026

Key points

  • Epoxy is tough, sticks well and resists chemicals, but tends to chalk in sunlight
  • Polyurethane holds colour and gloss outdoors
  • Acrylic is typically fast-drying and easy to use
  • The best system often combines more than one

Epoxy

Epoxy coatings usually come in two parts, a base and a hardener, that react together. They are known for strong adhesion, hardness and resistance to many chemicals and to wear. Outdoors in sunlight they tend to chalk, so they are often covered with a UV-stable topcoat.

Polyurethane (PU)

Polyurethane finishes are hard and durable, and are chosen where colour and gloss must last outdoors. Two-pack PU is often used as a topcoat over epoxy primers in industrial systems.

Acrylic

Acrylic coatings are often single-pack and quick drying, with good colour retention. They suit general protection and decoration where the chemical and wear demands are lower.

EpoxyPolyurethaneAcrylic
PacksUsually twoOften twoOften single
StrengthAdhesion, chemical and wear resistanceGloss and colour retention outdoorsFast drying, ease of use
Watch forChalking in sunlightMixing and pot lifeLower chemical resistance
Typical rolePrimer, build coat, liningTopcoatGeneral finish

In the IMPREUS range

The range includes two-pack epoxy products, such as Epoxy Primer (4:1) and Rebar Epoxy Coating (4:1); Grafted Co-Polymer PU Finish Paint, a two-pack polyurethane finish; and Quick Dry Acrylic Paint, a single-pack acrylic. Each product page gives its own details.

Choosing

Choose by the conditions: chemicals, heat, sunlight, abrasion and how quickly the job must return to service. For a first view, try the "Find my coating" guide, then confirm with our team.

Ask a question about this topic

Not sure how this applies to your asset? Send a short question and our technical team will reply by email.

This article is general guidance. Always follow the surface preparation, mixing, application and safety information on the product's approved technical data sheet. Standards are listed for reference.

References

  • ISO 12944-5: Protective paint systems
Technical consultation

Not sure which coating is right?

Tell us about your asset, surface condition and operating environment. Our technical team will help you identify a suitable solution.

Chat on WhatsApp