Industrial Paints, Specialty Coatings & Anti-Rust Solutions
Home/Reference/Articles/Problems and fixes

Paint Peeling and Flaking

Peeling means the paint has lost its grip, either on the surface or on the coat below it. The cause is nearly always in the preparation or the coating system.

Problems and fixes · 2 min read · Updated 18 Nov 2026

Key points

  • Peeling is a loss of adhesion
  • Dirt, oil, loose rust and mill scale under the paint are common causes
  • Wrong or incompatible coats, and missed recoat windows, also cause it
  • The fix is to remove the failed coating and prepare properly again

Where the paint lets go matters

Look at the back of a peeled flake. If it is clean and shiny, the paint did not grip the surface below. If steel is bare and clean, the primer failed to bond. If the flake has a layer of another paint, the coat did not grip the coat underneath.

Common causes

  • Oil, grease, dust, loose rust or mill scale left on the surface.
  • Not enough surface profile, so there was nothing for the coating to grip.
  • Applying the next coat after the maximum recoat time, so the old coat is too hard and smooth to bond.
  • Using a coating that is not compatible with the one below it.
  • Moisture or salts under the film.
  • Applying too thick a coat, which builds stress as it cures.

How to check adhesion

Simple tests include a cross-cut test and a pull-off test. These give a measured result, not just a guess. Your inspector or the technical data sheet can say which test is appropriate.

How to fix it

  • Remove all loose and poorly attached coating.
  • Clean and prepare the surface to the level in the data sheet (for example blasting to Sa 2.5 where required).
  • Spot-prime bare areas, then repaint with a compatible system at the right thickness.
  • Feather the edges of sound old paint so the new coat blends in.

How to prevent it

Treat preparation as the main job. Clean the surface, follow the data sheet, keep to recoat intervals and do not mix coating families without checking compatibility.

Ask a question about this topic

Not sure how this applies to your asset? Send a short question and our technical team will reply by email.

This article is general guidance. Always follow the surface preparation, mixing, application and safety information on the product's approved technical data sheet. Standards are listed for reference.

References

  • ISO 4628-5: Assessment of degree of flaking
  • ISO 2409: Cross-cut test
  • ISO 4624: Pull-off test for adhesion
Technical consultation

Not sure which coating is right?

Tell us about your asset, surface condition and operating environment. Our technical team will help you identify a suitable solution.

Chat on WhatsApp