Industrial Paints, Specialty Coatings & Anti-Rust Solutions
Home/Reference/Articles/Application

Weather and Painting: Dew Point, Humidity and Temperature

The weather on the day decides whether a coating cures and sticks properly. The dew point is the number to watch.

Application · 2 min read · Updated 18 Nov 2026

Key points

  • Steel should be warmer than the dew point, a common rule is at least 3 °C above
  • High humidity slows drying and can trap moisture
  • Surfaces in the sun can be much hotter than the air
  • Always check the temperature and humidity limits on the data sheet

What dew point is

The dew point is the temperature at which water condenses out of the air. If the steel is at or below the dew point, a thin film of water forms on it, often too thin to see. Paint put over it will trap that water.

The 3 °C rule

A common practice is to coat only when the steel temperature is at least 3 °C above the dew point. Steel can be colder than the air, especially at sunrise or in shade, so the steel temperature, not just the air temperature, should be measured.

Dew point check

–Dew point, °C
–Steel above dew point, °C

Estimate using the Magnus formula. Measure the steel temperature with a surface thermometer. Always follow the limits on the product data sheet.

Humidity

Many coatings state a maximum relative humidity for application. In humid air, solvent-based paints dry slowly and waterborne paints can take much longer. Condensation overnight on a half-cured coat can damage it.

Temperature

  • Too cold: cure slows or stops, especially for two-pack coatings.
  • Too hot: the surface skins over, trapping solvent, and pot life gets shorter.
  • Sun on dark steel can raise the surface temperature well above the air temperature.

Other conditions

Avoid painting in rain, fog, strong wind or dust. Wind can cause overspray and dust in the film. Follow the limits on the product data sheet.

Ask a question about this topic

Not sure how this applies to your asset? Send a short question and our technical team will reply by email.

This article is general guidance. Always follow the surface preparation, mixing, application and safety information on the product's approved technical data sheet. Standards are listed for reference.

References

  • ISO 8502-4: Guidance on estimating the probability of condensation prior to paint application
  • ISO 12944-7: Execution and supervision of paint work
Technical consultation

Not sure which coating is right?

Tell us about your asset, surface condition and operating environment. Our technical team will help you identify a suitable solution.

Chat on WhatsApp