Industrial Paints, Specialty Coatings & Anti-Rust Solutions
Home/Reference/Articles/Surface preparation

Surface Preparation Standards at a Glance

Data sheets quote preparation grades such as Sa 2½ or St 2. Here is what the common ones mean in plain words.

Surface preparation · 2 min read · Updated 18 Nov 2026

Key points

  • Sa grades describe blast cleaning, from light (Sa 1) to very thorough (Sa 3)
  • St grades describe hand and power-tool cleaning
  • Rust grades A to D describe the starting condition of the steel
  • Most protective coatings are specified with Sa 2½ or similar
GradeIn plain wordsClose to
Sa 1Light blast: loose mill scale, rust and coating removedSSPC-SP 7
Sa 2Thorough blast: most mill scale, rust and coatings removedSSPC-SP 6
Sa 2½Very thorough blast: only slight staining leftSSPC-SP 10 (NACE No. 2)
Sa 3Blast to visually clean steelSSPC-SP 5 (NACE No. 1)
GradeIn plain words
St 2Thorough hand and power-tool cleaning, with a faint metallic sheen
St 3Very thorough hand and power-tool cleaning, with a distinct metallic sheen

Starting condition (rust grades)

ISO 8501-1 also describes the starting condition of steel: A (mostly mill scale, little rust), B (rusting, some scale flaking), C (scale rusted away, slight pitting) and D (general pitting). The worse the grade, the more preparation is needed.

The other half: cleanliness and roughness

  • Surface cleanliness covers dust, oil, grease and soluble salts (see ISO 8502).
  • Roughness (the surface profile, ISO 8503) gives the coating something to grip, and data sheets give a range in microns.

Using this in practice

Follow the grade on the product data sheet. For example, IMPREUS High Build Glass Flake Epoxy Coating asks for bare steel blasted to Sa 2.5 with a 50 to 100 micron profile, and IMPREUS Solvent Free Epoxy Food Grade Coating recommends blasting to Sa 2.5 with a 50 to 75 micron profile.

Ask a question about this topic

Not sure how this applies to your asset? Send a short question and our technical team will reply by email.

This article is general guidance. Always follow the surface preparation, mixing, application and safety information on the product's approved technical data sheet. Standards are listed for reference.

References

  • ISO 8501-1: Visual assessment of surface cleanliness
  • ISO 8502: Tests for the assessment of surface cleanliness
  • ISO 8503: Surface roughness of blast-cleaned steel
  • SSPC and NACE joint surface preparation standards
Technical consultation

Not sure which coating is right?

Tell us about your asset, surface condition and operating environment. Our technical team will help you identify a suitable solution.

Chat on WhatsApp