Industrial Paints, Specialty Coatings & Anti-Rust Solutions
Home/Reference/Articles/Problems and fixes

Pinholes and Cratering in Coatings

Pinholes are tiny holes through a coating. Craters are small round dents. Both leave gaps where water and rust can reach the steel.

Problems and fixes · 2 min read · Updated 18 Nov 2026

Key points

  • Pinholes can go right through the film to the steel
  • Trapped air or solvent, rough or porous surfaces and spray technique are common causes
  • Craters come from oil, silicone or dirt on the surface
  • Small defects in a barrier coating can lead to early failure

Pinholes

Pinholes are fine holes in the film. They often come from air or solvent bubbles that burst while the coating is drying and do not close up again. Rough or porous surfaces, such as some welds, castings or old repairs, trap air. Over-thick coats and spraying too close or at too high a pressure can also cause them.

Craters and fish-eyes

Craters are small round dents where wet paint has pulled away from a spot. The usual cause is a trace of oil, grease, silicone or other contamination on the surface or in the air. Even fingerprints and spray from other products can do it.

Why they matter

In a barrier coating, each defect is a path for water and salts. On a lining or tank coating, a pinhole can lead to local corrosion that spreads under the film.

How to prevent them

  • Clean and degrease the surface well. Keep silicone products away from the work area.
  • Fill or seal rough or porous areas as the data sheet advises.
  • Apply in even coats at the specified thickness.
  • Give each coat the time it needs to release solvent before recoating.
  • Check the finished coating, for example with a spark test (holiday test) for linings.

How to repair them

Remove the affected area, clean, and repair with the same system following the data sheet. Pinholes in a lining should be repaired and re-tested.

Ask a question about this topic

Not sure how this applies to your asset? Send a short question and our technical team will reply by email.

This article is general guidance. Always follow the surface preparation, mixing, application and safety information on the product's approved technical data sheet. Standards are listed for reference.

References

  • ISO 29601: Paints and varnishes, corrosion protection by protective paint systems, assessment of porosity in a dry film
  • NACE SP0188: Discontinuity (holiday) testing of new protective coatings on conductive substrates
Technical consultation

Not sure which coating is right?

Tell us about your asset, surface condition and operating environment. Our technical team will help you identify a suitable solution.

Chat on WhatsApp